. Instructions for installing modern plumbing systems. etween thecheck valve and its seat, allowing the waterto pass back through the pump into thesource of supply. If the seat or valve havebeen worn so they do not set firmly, thevalve can be ground down into the seat byapplying fine emery and turning the valveon its seat. This will regrind it and makeit absolutely tight. SEARS, ROEBUCK AND CO., CHICAGO. Directions for Installing Sink Outfits Installing 42—9075V4 HerculesSink Outfit. The outfit consists of a east iron sink, porcelainenameled inside; a pitcher spout pump, the cyl-inder of which
. Instructions for installing modern plumbing systems. etween thecheck valve and its seat, allowing the waterto pass back through the pump into thesource of supply. If the seat or valve havebeen worn so they do not set firmly, thevalve can be ground down into the seat byapplying fine emery and turning the valveon its seat. This will regrind it and makeit absolutely tight. SEARS, ROEBUCK AND CO., CHICAGO. Directions for Installing Sink Outfits Installing 42—9075V4 HerculesSink Outfit. The outfit consists of a east iron sink, porcelainenameled inside; a pitcher spout pump, the cyl-inder of which is brass lined; a pump board, threesteel sink brackets, a lead sink trap, a piece of l%-inch pipe 3 feet long and a piece of lj^-inch pipe2 feet 6 inches long. Fasten two of the brackets securely to the wallso when the sink is placed upon them the top edge(,r rim will be level, or as near so as possible, andthe distance from the floor to the top of thesink will not be over .2 feet 6 or 8 inches. Thethird bracket is then fastened to the wall so the. 1,3— 907SM Coupling. outer edge of the pump board rests upon it, while i other end is supported by the sink rim. Slant or pitch the board slightly toward the sink so tltat any water spilled upon it will drain into the sink. After cutting or boring a hole through the board for the suction pipe, the pump is ned to the board with ordinary iron wood .s or bolts. The sink, pump and board ate then placed Upon the hrackets, and the strainer is fastened to the sink with the two short screws the trap with the two long ones. The trap is connected by slipping the sink coupling (see small illustration) over the end of the trap, after which tin opening in the trap is flared out by beating it the inside with a round rod or smooth piece of hardwood until it fits over the opening in the Ordinary putty is then put between the trap ami sink outlet and the coupling is drawn up tight with tlie two long bolts or screws. When putting the putty betwee
Size: 2122px × 1178px
Photo credit: © The Reading Room / Alamy / Afripics
License: Licensed
Model Released: No
Keywords: ., bookcentury1900, bookdecade1920, booksubjectdivisio, bookyear1922
